#PROSELECT CONDENSATE PUMP RED LIGHT MANUAL#
#PROSELECT CONDENSATE PUMP RED LIGHT SERIES#

Confirm illumination of the unit lockout LED.

Emergency heat operation will be triggered if the thermostat requires heating. The accessory outputs and compressor will be de-energized. When the unit enters lockout mode, the relevant lockout LEDs will illuminate on the unit and thermostat. An automatic reset will be triggered, and the lockout condition will not be entered. All four-fault LEDs will flash, and the “Call For Service” indicator will illuminate. Voltage faults trigger the initiation of a fault and a shutdown of the compressor.

Power it back on (this is called a “soft reset”).ĭisruption of power to the board will cause the fault memory to be reset.

Power the thermostat off for one minute.

#PROSELECT CONDENSATE PUMP RED LIGHT SERIES#

GeoComfort Guide Series With Core Display The programming or configuration options will not be altered by a reboot. You may reboot the thermostat by pressing the hardware reset button, accessible through an opening on the corner at the thermostat’s bottom left. In exceptional circumstances, the operation of the thermostat may be interrupted by power surges or static electricity.

Select “HVAC Equipment Settings” and then “Yes.”.

To reset everything, including user settings, select “Reset All Settings.” This will not affect user settings, which will remain unchanged. ClimateMaster Series with iGate ControlsĪll equipment factory settings can be restored.

Press (don’t hold) the left arrow button to exit the “Accessory Status” screen.

Cycle through the remaining applications by repeating steps 2 and 3.

Reset the chosen application by pressing the button beside the right arrow.

Choose one, e.g., “Hum Pad,” for the humidifier pad. Abbreviated descriptions occur for each item.

Use the “Scroll” button to page through the accessories.

The screen will display the names of accessories.

Hold down the button beside the left arrow until the screen displays “Accessory Status.” This will last several seconds.

Carrier GC Series with Infinity Thermostat

Switch the heat pump power switch back on.

Bring the system up by switching components on in reverse order:.

There are two electrical breakers serving the heat pump.

The heat pump’s power switch is located either at the edge of the heat pump or on the adjacent wall.

If the pump displays an orange or red light, a reset is required: There is no need to restart if the heat pump displays a green light. When the switch is set to “R,” shut off unit power at the circuit breaker. When the switch is set to “Y,” turn the thermostat off and then back on. To recover from a hard lockout, refer to the “RESET” dip switch.

#PROSELECT CONDENSATE PUMP RED LIGHT MANUAL#

Should the fault persist or, within sixty minutes, occur the number of times indicated on the lockout dip, the unit will enter a hard lockout, requiring a manual reset.Ī hard lockout will also be triggered on the first instance of a condensate overflow. The lockout dip switch has a prior setting of 2 or 4. The fault LED will flash the cause of the fault during the delay. It restarts after the expiry of this period. On autodetecting fault condition, the unit initiates a 5-minute delay on break time. A user is required to manually intervene only in certain instances where a hard lockdown has been triggered. These units have intelligent reset, which takes the guesswork out of when to intervene. For each brand, reset instructions are provided. Search for your model, which is likely to be in one of the series. The series below are amongst the top efficiency-rated brands by Energy Star. 12 Resetting Other Brands Reset Instructions For Leading Geothermal Brands

Proselect condensate pump red light